How to Fix Slime that Didn't Work Out (2024)

I looooove play recipes. So it always bums me out if people can't get them to work (by the way, I'm always happy to help you troubleshoot any of our recipes if you send me a photo!). Slimes in particular seem to cause a lot of trouble for folks, so when I was writing our book,How to Fix Slime that Didn't Work Out (1) I decided to do a bit of investigating. I learned a ton about what probably goes wrong for those of you who have slimes that don't work - and I also figured out how to fix a slime fail! I hope this will help those of you who have not had success with slime recipes!

How to Fix Slime that Didn't Work Out (2)
This post contains affiliate links for your convenience.

So first thing's first - the slime recipe that I decided to troubleshoot is the one that uses clear glueHow to Fix Slime that Didn't Work Out (3) (aka PVA) and liquid starchHow to Fix Slime that Didn't Work Out (4) (Sta Flo) since it seems to be the one that causes the most trouble for folks. (If you are using our laundry detergent recipe, you can follow this same set of directions. Keep in mind that the laundry detergent is a direct substitute for liquid starch.) The first interesting thing I learned is that over time the liquid starch will settle. This was leading to a lot of inconsistency in and of itself. So the first thing I learned about this slime recipe is:

Always shake your liquid starchHow to Fix Slime that Didn't Work Out (5) container a bit to make sure that it is well-mixed.

Now that you've shaken your liquid starch, let's look at the two ways this slime can go wrong.

First way: Not enough liquid starch

How to Fix Slime that Didn't Work Out (6)

How do you know if this is your issue? Your slime will be stringy - it will stick to your fingers (see how much is sticking to mine above?) a ton. As you stir, you'll see little strings of glue grabbing your spoon. If you grab a section of your slime, it won't lift out in a glob - just a small stringy portion will stretch up.

How to Fix Slime that Didn't Work Out (7)

Remedy? Add more liquid starch, approximately one Tablespoon at a time. Stir well to mix in between each addition of liquid starch. You'll know you've added enough when you no longer see those strings of glue grabbing your spoon as you stir, and you'll be able to lift all or most of the slime out if you grab a section of it. After a few minutes of kneading it will be beeeautiful and not sticky.

How to Fix Slime that Didn't Work Out (8)

Second way: Too much liquid starch

A slime that's had too much liquid starch added will be stringy, but NOT sticky. It won't stick to your fingers - it will slide right off. It won't stick to a spoon or even to itself. It's just gross looking clumps of goo (seriously SUPER gross).

How to Fix Slime that Didn't Work Out (9)

You can see strands of floating slime, and there will be standing liquid starch.

How to Fix Slime that Didn't Work Out (10)

How do you fix it? First, pour off any standing liquid starch. Then add clear glueHow to Fix Slime that Didn't Work Out (11) approximately 1/4 cup at a time and stir. Once the slime starts holding together, you will need to knead it by hand. After adding glue and kneading for 2-3 minutes, it will be just like new! It will gel even more if left overnight in a sealed bag.

How to Fix Slime that Didn't Work Out (12)

So what does perfect slime look like? It holds together and doesn't have any strings of glue or standing liquid starch.

How to Fix Slime that Didn't Work Out (13)

If you grab it, it moves as one cohesive unit.

How to Fix Slime that Didn't Work Out (14)

Kneading it for a minute or two will make it gel into a smoother and more uniform slime.

How to Fix Slime that Didn't Work Out (15)

Because we've noticed that the amount of liquid starch needed varies wildly from slime to slime (depending a ton on what you add to it - food coloring, liquid watercolors, glitter, etc), I really recommend adding whatever amount of glue you'd like (we usually make a slime batch with two bottles of clear glueHow to Fix Slime that Didn't Work Out (16), but even one bottle makes a pretty solid amount of slime) to a container and then slowly adding liquid starchHow to Fix Slime that Didn't Work Out (17) - about 1 Tablespoon at a time - and stirring between each addition until you have slime that looks like the blue slime pictured in the cup above.

Once you've made your slime, be sure to knead it for a few minutes to make it uniform (honestly, you can just hand it to your kid to play and that will mix it for you!). Store it in an airtight container or Ziploc bag when you aren't using it. It will keep for several weeks.

And don't worry if it bubbles. That's normal.

How to Fix Slime that Didn't Work Out (18)

My final awesome discovery was that vinegar will dissolve this slime - just in case you get any on your carpet or clothing!

I hope this helps those of you who have had slimes backfire on you in the past!

Oh and if you are from the UK and looking for how to make slime with UK ingredients - you can find the answer to that in this post!

Follow along with Fun at Home with Kids onFacebook,Google+,PinterestorSubscribe by Emailor Bloglovin'!

All activities here are activities I feel are safe for my own children. As your child's parents/guardians, you will need to decide what you feel is safe for your family. I always encourage contacting your child's pediatrician for guidance if you are not sure about the safety/age appropriateness of an activity. All activities on this blog are intended to be performed with adult supervision. Appropriate and reasonable caution should be used when activities call for the use of materials that could potentially be harmful, such as scissors, or items that could present a choking risk (small items), or a drowning risk (water activities), and with introducing a new food/ingredient to a child (allergies). Observe caution and safety at all times. The author and blog disclaim liability for any damage, mishap, or injury that may occur from engaging in any of these activities on this blog.

How to Fix Slime that Didn't Work Out (2024)

FAQs

How to Fix Slime that Didn't Work Out? ›

Add more liquid starch, approximately one Tablespoon at a time. Stir well to mix in between each addition of liquid starch. You'll know you've added enough when you no longer see those strings of glue grabbing your spoon as you stir, and you'll be able to lift all or most of the slime out if you grab a section of it.

How do you fix slime that didn't work? ›

Sometimes you can fix this slime by kneading it for a couple of minutes (and also draining off any standing liquid). If kneading it doesn't work, try adding additional glue.

How to fix slime that is too runny? ›

Cornstarch or flour can help absorb any excess liquid in your slime and thicken it. Start by adding a small amount and kneading it into the slime until you achieve the desired consistency. Depending on how runny your slime is, you could add as little as a pinch or as much as a couple of tablespoons.

How do I fix over-activated slime? ›

EASY FIX: Simply give your slime some rest and don't touch it for a couple of hours/days (depending on the amount of bubbles). This process can be sped up by keeping your slime in a warm place.

How to make slime more stretchy? ›

You can make slime stretchy again by adding a bit of lotion. Simply add a squirt of lotion into the middle of the slime, then knead it until the slime is stretchy again. Add more lotion, if necessary, to get the texture you want. You can also use hot water to make slime stretchy again.

What can work as a slime activator? ›

Slime is made when a polymer interacts with a gelling agent. Typical slime recipes call for clear or white PVA glue (the polymer) and an activator (gelling agent). The activator is usually powdered borax dissolved in water, liquid starch, eye drops, or contact lens solution.

How do you fix slime that is too jiggly? ›

Add a bit of water.

You likely won't need more than spoonful. Then just knead away until the slime softens. Remember, water can make or break your slime. Make sure you only add a little bit of water if you don't want jiggly slime.

Is hand sanitizer a slime activator? ›

Hand sanitizers are utilized to make slime because, just like body lotions, hand sanitizers can also have the same effect on slime. People use hand sanitizers to make slime because they give moisture to it and have the perfect stretchy consistency that slime should have.

Is slime a permanent fix? ›

Slime's Emergency Tire Sealant is not a long-term solution. You should remove the formula within 3 days or 100 miles. Thru-Core Emergency Tire Sealant (yellow label) is also designed for use on highway vehicles experiencing a flat tire emergency.

How to make slime less liquidy? ›

To fix watery slime easily, add in a thickening agent to make it the right consistency. If you have borax slime, mix in 1/4 tablespoon of borax at a time to thicken it. If your slime is made with liquid starch, add 1/4 cup of clear glue, and mix the slime thoroughly.

Why didn't my slime work? ›

Common Slime Problems:

You might need to remake your slime. Won't gel: There are two reasons this can happen: 1) you didn't wait 3-5 minutes for the bonds to form, or 2) you didn't add enough starch. Wait five minutes, then if it still isn't gelling, try adding a bit more starch.

What does lotion do to slime? ›

If your slime feels tough or rippy, add lotion to soften it (as a clear slime, we recommend glycerin).

How do you fix dead slime? ›

Add a bit of water.

It's true, some slimes can be revived this way. Put the slime in a bowl, and add a small amount of water to it. You likely won't need more than spoonful. Then just knead away until the slime softens.

How to reactivate slime without activator? ›

Hold dried-out slime under warm running water or dunk it in a bowl of warm water for 1 second at a time, then play with the slime in your hands to mix the water in. Repeat this as many times as needed until the slime becomes moist and stretchy again.

Why won't my slime activate with contact solution? ›

Make sure your contact solution has boric acid and sodium borate on its ingredients list. Otherwise, the slime will not work. Knead the slime with your hands as you add the contact solution to help make the texture more slimy.

What to do if your slime is rippy? ›

If your slime feels tough or rippy, add lotion to soften it (as a clear slime, we recommend glycerin).
  1. Store slime in an air tight container.
  2. Check in on your slime regularly and activate when it's necessary; the more attention it gets, the more it will thrive.

Top Articles
Latest Posts
Article information

Author: Francesca Jacobs Ret

Last Updated:

Views: 5516

Rating: 4.8 / 5 (48 voted)

Reviews: 87% of readers found this page helpful

Author information

Name: Francesca Jacobs Ret

Birthday: 1996-12-09

Address: Apt. 141 1406 Mitch Summit, New Teganshire, UT 82655-0699

Phone: +2296092334654

Job: Technology Architect

Hobby: Snowboarding, Scouting, Foreign language learning, Dowsing, Baton twirling, Sculpting, Cabaret

Introduction: My name is Francesca Jacobs Ret, I am a innocent, super, beautiful, charming, lucky, gentle, clever person who loves writing and wants to share my knowledge and understanding with you.